How To Reset Blink Camera To Factory Settings. If your blink camera is offline, you can often just power cycle your internet router or sync module to get your camera back online. Blink mini can also be connected to the sync module and if your blink mini is connected to the sync module then use the above steps for resetting using the sync module.
To help restore your settings after resetting your camera, write down or take a screenshot of your camera settings.; All settings will be restored to factory default. Immediately press and hold the reset button just to the right of the yellow lithium only sticker for 10 seconds.
How To Factory Reset Blink Outdoor Battery Cameras.
Scan or enter the module’s serial number then tap “delete”. The blink mini has a reset button on the bottom side of the camera, which may be necessary to use when you add it to a new or existing blink system. This is common when the reset button doesn’t work properly
Www.techsolutions.support.com Hold Down The Reset Button For Up To 30 Seconds, Or Until The Light Flashes On.
Go back to the home screen and click on the + sign (to add the system_. All settings will be restored to factory default. Insert both batteries back into the camera.
Open The Home App Or The Nest App.
Scan or enter the module’s serial number again. The reset button can be found beside the ubs port on the side of your blink camera. When the reset is complete, you will see a solid green light and a blue light.
Camera Reset Instructions Grab A Pin Or Paperclip As You'll Need This During The Process.
Blink mini can also be connected to the sync module and if your blink mini is connected to the sync module then use the above steps for resetting using the sync module. Hold the button until the light turns red. Select menu → setup → initialize → reset default or factory reset.
The Length Of Motion Clips To Be Recorded;
Restore—press and hold the recessed reset button until the status led rapidly blinks. To reset the blink module, press and hold the reset button for at least 10 seconds. Select menu → settings → initialize → ok.